Worth Data LZ404-RF Einstellungsanleitung PDF herunterladen (Seite 16)

Note: If you are using the 2D 520-RF then refer to the 2D setup chart starting on page 24.

2 of 5 Code

Enable Interleaved 2 of 5

Disable Interleaved 2 of 5

Enable Interleaved 2 of 5 Check Digit

Disable Interleaved 2 of 5 Check Digit

Enable Check Digit Transmission

Disable Check Digit Transmission

Enable Standard 2 of 5

Disable Standard 2 of 5

Enabling the Check Digit requires the data’s unit’s position to match the calculation for the check digit. If

you've enabled the check digit, enabling Check Digit transmission causes the reader to transmit it to your

computer along with the bar code data.

2 of 5 Data Length

2 of 5 Code is so susceptible to interpreting partial scans as valid reads that the Radio/Freedom Reader

uses fixed-length data as a safeguard. To choose a data length, scan it as a two-digit number using the Barpad

Table. For example, to select 8-digit data length, you would scan a 0 and then an 8. Because Interleaved 2

of 5 is required to be an even number of digits in length, you must use an even number. If you're unsure of

your bar code length, temporarily set the length to 00, read a bar code, and count its digits and then set it to

the actual length. DO NOT PERMANENTLY SET THE 2 of 5 LENGTH TO 00 or you will get

misreads!

Code 93

Enable Code 93

Disable Code 93

Enable Full ASCII Code 93

Disable Full ASCII Code 93

1 2 ... 11 12 13 14 15 16 17 18 19 20 21 ... 72 73

Keine Kommentare

Worth Data LZ404-RF Einstellungsanleitung Seite 16